What We Inspect

Exterior

We check the home’s exterior including slope of site around home, retaining walls, fences, testing gates, driveways and walkways, decks and patios, porches and porch structures (including foundations and mechanical connections), steps and stairs, walls, trim, fascia and soffit, doors, windows, and trim. We note proximity of trees and tree roots, and also look at adjoining properties for similar conditions.

Crawl Space

In houses with a first-floor that is elevated above grade, the inspectors will enter the crawl space (where accessible) and examine foundation piers, structural connections, beams and floor joists, exposed utilities, insulation, ventilation, and check for signs of moisture or insect damage.

Structure

We do a complete visual inspection of the entire structure. The inspectors look for signs of moisture intrusion at walls, windows, and eaves, and evaluate cracks and other visible structural defects. An infrared camera and moisture meter is used as part of this process. We use a video borescope when necessary to view confined areas

Interior Rooms

We walk through all interior rooms and check for signs of water damage or other problems. The inspector also tests all windows and doors, and examines screens. We briefly test any major appliances that convey with the sale.

Garage

Exterior and interior inspection of the garage. We test the garage door opener for required safety controls and operation.

Attic

The inspectors enter the attic (where accessible) and check for signs of structural problems, such as damaged trusses, undersized structural components, and damaged sheathing. We document roof tie-down connections, insulation type and R-value, and ventilation system. Attic stairs are examined for proper installation and function, and any evidence of rodent infestation is noted.

Roof

The condition of the roof is the #1 concern of most homebuyers. We walk the roof where possible, and report on the condition, estimated age, and any observable defects. For asphalt shingle roofs, we inspect for correct slope, granule loss, and tab adhesion. We examine flashings for proper installation at skylights, roof-to-wall junctions, chimneys, and roof edge. We determine if electric service masts and plumbing vent pipes are properly waterproofed. We check for correct panel installation on metal roofs, including edge overhang, penetration waterproofing, screw spacing, and dissimilar metals. We estimate the age of the roof and its likely additional life. Because we are licensed contractors, we can also provide a “roof letter” to certify the condition of the roof when requested by your insurance company, at no additional charge. We check for evidence of poor drainage, leakage, and debris in gutters and downspouts.

Electrical

We open the cover on the main electrical panel to check for signs of defective or amateur wiring. We also check wiring and fixtures throughout the house with a circuit analyzer and report ungrounded or reverse polarity outlets, defective or damaged wiring, and test ground-fault-circuit-interrupters, switches, smoke alarms and ceiling fans. AFCIs and GFCIs are tested.

Plumbing

We check the water supply, waste, and vent pipes for signs of leaking or other defects. We check the water heater for safety issues and signs of trouble, and determine it’s age, capacity, and condition. We confirm that the water pressure is sufficient for normal use, and check kitchen and bath fixtures for proper operation or damage.

Air Conditioning and Heating

We operate the system, check filters, ducts and registers, test it for proper installation and operation, and determine age, capacity, and condition of system. We measure both the hot and cold temperatures.

Appliances

We examine and test all major laundry and kitchen appliances that are installed and convey with the sale, running them through a short cycle and checking safety features.

Wells

We do a visual inspection of above-ground equipment, and test water sample on-site for hardness, ph, and iron.

Sprinkler Systems

We test the system in manual mode for function in each zone, looking for broken, damaged or leaking heads, and any areas of overspray onto house walls.